Drone Wiring Diagrams

Components needed to create drone:

ESC or electronic speed control

Frame: there are two possibilities when it comes to the frame for your drone. You can make your own or buy it in an online store, and for a wide selection of high quality frames, we recommend checking out the best drone frame articles. If you decide to build it yourself, the project is not that difficult, but you need knowledge and technical knowledge about the material you will use. For example, you can use metal (something lightweight), plastic, or even wooden slats. If you choose wooden frame.

Motor: For a regular quad, you will need 4 motors in total, but octocopter requires eight motors to fly. The recommendation is to use a brushless motor - they are lighter on battery and, unless you're an engineer who really understand how motor works, these pieces have to be bought from the store.

ESC or electronic speed control: this is also an important part of your drones as they are tasked with sending power to the motor. Again, their number depends on the amount of material your drone will have.

Propeller: When looking for propellers, you have to find a propeller that matches your drone frame. Watch the material - you will not find wooden propellers, but you have to make sure that you choose to match.

Connectors: You need a 3.5 mm connector for welding and ESC motors, as well as a 4.5 mm connector for power distribution boards.

Power distribution board - this board connects the electronic speed control to the battery.

Battery: When purchasing a battery for your drones, you need to consider the capacity of the battery and its type. The most widely used battery for this purpose is the Li-Po battery and its power is different. To get a much better insight on this topic, we highly recommend reading the drone battery article.

Battery monitor: This is not a basic item, but the monitor is useful enough to alert you when the battery is almost complete. This way you are not at risk of having drones fixed out of the juice in the air, above the pool.

Mount pad: It reduces vibration, and thus increases the flight. This is very useful if you are trying to take pictures or videos with your DIY drones.

Controllers - This device divides power and instructs the motor at the same time.

RC Receiver: Of course, if you have a transmitter (which is usually with you), you will also have a receiver installed on an unmanned aircraft.

Camera: If you want to take aerial photos and record around while flying your drones, you will need a camera. The best camera is a camera that can take quality 4K video.

USB Key: It is important to store photos and videos. This is the most important part that every drone should have to work and fly.

Apart from the above mentioned sections, you will also need a silicon AWG cable, battery charger, servo wire servo cable, zip fastener, 3M command strip, yarn locking compound, etc.

Description taken from several sources.

- Create simple drones in a simple and inexpensive way

- How to create a DIY Drone

- How to build Drones for beginners

- Drone wiring diagram.

- etc.